Excavation, septic systems and custom homes from Billings to BozemanExcavation and dirt work in Reed Point, MT
Call or text (808) 561-7893 Licensed, Insured and Bonded
IP Construction
Excavation contractor in Bozeman, MT
Call (808) 561-7893 Request a Quote

How Much Does Septic Tank Installation Cost in Montana?

National cost guides put a new conventional septic system at about $3,000 to $8,500 installed. One guide’s 2026 national average is $8,011, drawn from 1,277 projects. Most of those homeowners paid between $3,586 and $12,463.

Your soil decides how far past that range you go. Mound systems run $10,000 to $20,000 in one guide and $25,000 to $50,000 or more in another. These are market numbers, not our price list. For septic system installation around Reed Point, the site evaluation and the county permit set the real number.

What do national cost guides say a septic system costs?

National cost guides publish installed ranges by system type. They agree on conventional systems and split widely on mounds and aerobic units.

System typePublished installed costSource
Conventional (gravity)$3,000 to $8,000National cost guide, 2026
Conventional (gravity)$3,500 to $8,500Second national cost guide, 2025
Pressure distribution$7,000 to $10,000Older national cost guide, 2023
Sand filter$7,000 to $18,000National cost guide, 2026
Mound$10,000 to $20,000National cost guide, 2026
Mound$25,000 to $50,000 or moreSecond national cost guide, 2025
Aerobic treatment unit$10,000 to $20,000National cost guide, 2026
Aerobic treatment unit$20,000 to $40,000 or moreSecond national cost guide, 2025

Labor is the biggest share: 50 to 70 percent of the total, in the 2026 guide. The second guide adds that remote sites cost more in labor, since heavy equipment has to travel farther.

Which system will the county require on your lot?

In Montana, the county environmental health office reviews the site and issues the septic permit. The design follows Circular DEQ-4, the state’s septic standards from the Montana Department of Environmental Quality (DEQ).

The site evaluation comes first. Soil pits go 8 feet deep unless a limiting layer, such as groundwater or bedrock, shows up sooner. The standards keep at least 4 feet of natural soil between the bottom of the drainfield and that limiting layer.

What the soil pits show steers the price:

  • Standard gravity trenches fit deep, well-drained soil. Each gravity trench can run 100 feet at most.
  • Pressure-dosed trenches add a pump in its own dose tank. The standards require pressure distribution once a drainfield needs more than 500 feet of line.
  • Gravel soils that drain faster than 3 minutes per inch must be pressure dosed and sand lined.
  • Elevated sand mounds build the drainfield up on sand where trenches would sit too close to the limiting layer. Every mound must be pressure dosed.

The dose tank does not count toward the septic tank’s required size. It is one more tank in the ground, with a pump and a high-level alarm.

How does tank size change the price?

Montana sizes the septic tank by bedrooms. The state standards set these minimums for one home:

BedroomsMinimum septic tank
1 to 31,000 gallons
4 to 51,500 gallons
6 to 72,000 gallons
8 or more2,000 gallons, plus 250 gallons for each bedroom over 7

National cost guides price a 1,000-gallon tank at $900 to $1,500, before installation. A 1,500-gallon tank lists at $1,500 to $2,500.

Count bedrooms the way the county does. Yellowstone County’s health department counts an unfinished basement as one bedroom. There, a three-bedroom house with an unfinished basement sizes as four bedrooms and needs a 1,500-gallon tank.

What do the site evaluation and the permit cost?

National cost guides list a perc test at $700 to $2,000. The second guide lists a soil test at $250 to $700. A deep-hole test by an engineer runs up to $2,000 there.

Design is the next line item. In Stillwater County, the county can design a standard system itself. When the design uses a pump or a sand mound, it may require an engineer or a sanitarian. The second guide lists engineering and design fees at $1,000 to $3,000.

National guides put permit fees at $450 to $2,300 and note that some places charge less. Two counties in our service area post their own fees:

FeeAmountSource
Septic permit, new or replacement$200Stillwater County fee schedule
Site visit, when required$275Stillwater County fee schedule
Installing without a permit$600, plus the permit and site visit feesStillwater County fee schedule
Inspection before the drainfield is backfilled$300 per drainfieldYellowstone County fee sheet, 2024
Subdivision review, gravity drainfield$120 per drainfieldYellowstone County fee sheet, 2024
Subdivision review, dosed system or mound$180 design review, plus $120 per drainfieldYellowstone County fee sheet, 2024

Fees change, so check the county office’s current schedule before you plan around a number. Skipping the permit costs more, as the table shows.

Groundwater can add time. Where groundwater could rise within 7 feet of the surface, Stillwater County may require monitoring wells first. Those wells go at least 8 feet deep and are read through the high-water season.

Why does the length of the run matter?

Every foot between the house and the drainfield means more trench and more pipe. In Stillwater County, the tank sits 10 to 50 feet from the foundation. An engineer’s design or county approval can change that.

The drainfield goes where the soil passes, and that spot may sit well away from the house. Setbacks from wells and property lines move it too. The state standards also require a full-size replacement area, so the lot needs room for a second drainfield.

If that ground sits uphill of the tank, the effluent has to be pumped. The pump needs its own dose tank. National guides list excavation at $1,500 to $6,300 when it is billed on its own. Rocky or wet sites push excavation costs up, one guide notes.

If you are building, plan the septic layout and the foundation excavation together. That way the tank sits where the county wants it.

What else should a rural lot plan for?

In Stillwater County, no part of the system may sit under a driveway or a parking area. The exception is a part designed for that load. Ponds and irrigation ditches built after the system stay 50 feet from the tank and 100 feet from the drainfield.

Water is the other big line item on a rural build. Some owners drill a well, and others install a buried water cistern. For the whole picture on a new home, see what it costs to build a house in Montana.

How do you get a real number for your lot?

Every figure above is a market number or a posted fee. Your soil test and the county’s permit decide the actual system. IP Construction installs new septic systems for homes, cabins, shops and rural lots from Billings to Bozeman.

We look at the site, then put a free estimate in writing. Read more about how we install a new septic system, or call or text (808) 561-7893.

Frequently asked questions

How much does a septic tank cost by itself?
National cost guides price a 1,000-gallon septic tank at about $900 to $1,500 before installation. A 1,500-gallon tank lists at $1,500 to $2,500. Labor and the drainfield make up most of the installed total.
What size septic tank does Montana require?
The state's septic standards size the tank by bedrooms. One to 3 bedrooms needs at least 1,000 gallons, and 4 to 5 bedrooms needs 1,500 gallons. Six or more bedrooms starts at 2,000 gallons, with 250 gallons added for each bedroom past 7.
When does Montana require a pressure-dosed septic system?
The state's standards require pressure distribution when a drainfield needs more than 500 feet of line. Every elevated sand mound and every sand-lined trench must be pressure dosed. Gravel soils that drain faster than 3 minutes per inch must be pressure dosed and sand lined.
Why would a lot need a mound system?
A mound builds the drainfield up on sand when trenches would sit too close to groundwater or bedrock. The state's standards still call for 4 feet of natural soil under the mound. One national cost guide lists mounds at $10,000 to $20,000, and another lists $25,000 to $50,000 or more.
Why might the county ask for groundwater monitoring?
Stillwater County may require it when groundwater could rise within 7 feet of the surface. The monitoring wells go at least 8 feet deep. The county reads them through the high-water season, until the level peaks and falls. Other counties set their own rules, so ask the county office early.
Does IP Construction repair or pump septic systems?
No. We install new septic systems for new homes and for properties that need a new system. Septic pumping and septic repair are work for another company, such as a septic pumper or a repair company.
Is this what IP Construction charges?
No. These are market numbers from national cost guides and county fee schedules, not our price list. Your soil and the county's permit set the real number. We look at your site and give you a free estimate, with the quote in writing. Call or text (808) 561-7893.
Request a Quote

Get In Touch With IP Construction

Send the form with the job you have in mind and where the land is. You can also call or text (808) 561-7893 for a free estimate.

  • Call or text (808) 561-7893
  • Serving Reed Point, MT and the country between Billings and Bozeman
  • Free estimate in writing · excavation, septic systems and custom homes

Request a Quote

Tell us about the septic system, foundation, driveway or new home and where the property is. We look at the job and put a free estimate in writing.

Call (808) 561-7893